Bottom Entry And Side Entry Circuit Board Pin Sockets; Multipin Connectors; Connector - Tektronix DC 5010 Anleitung

Bottom Entry and Side Entry Circuit Board Pin
Sockets
To remove or replace these sockets unsolder the pins
from the circuit board. Use a vacuum or other type
desoldering tool to remove excess solder. Use caution to
prevent circuit board damage. See Fig. 5-4 for bottom entry
socket example.
Fig. 5-4. Bottom entry circuit board pin socket.
Multipin Connectors
The pin connectors used to connect the wires to the
interconnecting pins are clamped to the ends of the wires.
To replace damaged multipin connectors, remove the old
pin connector from the holder. Do this by inserting a scribe
between the connector and the holder and prying the con-
nector from the holder. Clamp the replacement connector to
the wire. Reinstall the connector in the holder.
If the individual end lead pin connectors are removed
from the plastic holder, note the order of the individual wires
-
for correct replacement in the holder. For proper replace-
ment see Fig. 5-5.
END-LEAD
MULTI-PIN
CONNECTOR
HOLDER
END-LEAD
MULTI-PIN
CONNECTOR
MULTI-PIN
CONNECTOR
INDEX
Fig. 5-5. Orientation and disassembly of multipin connectors.