Electrical Characteristics - Tektronix DC 5010 Anleitung

Table 1-1
ELECTRICAL CHARACTERISTICS
r l
lnput Frequency Range
Coupling
DC
AC
Characteristics
lnput Sensitivity
Sinewave
Coupling Attenuation
CHANNEL A and CHANNEL B INPUTS (also see RiseIFall MEASUREMENT MODE INPUT SPECIFICATION)
Performance Requirements
Dynamic Range
Attenuation
XI
Supplemental Information
Trigger Level Range
Attenuator
X1
Trigger Level
Accuracy
50
Q
1 MQ
>O to a 3 5 0 MHz
>O to a 3 0 0 MHz
100 kHz to a 3 5 0 MHz 16 Hz to a300 MHz
50
Q
(Term low) 1 MQ (Term high)
~ 2 5 mV rms* ~ 2 5 mV rms to 200 MHz
~ 4 2 mV rrns from 200 MHz
to 300 MHz
~ 7 0 mV p-p pulse* ~ 7 0 mV p-p pulse
( t 2 0 0 MHz)
~ 1 2 5 mV rms*
GI
25 mV rms to 200 MHz
~ 2 1 0 mV rrns from
200 MHz to 300 MHz
~ 3 5 0 mV p-p pulse* ~ 3 5 0 mV p-p pulse
~ 2 5 mV rms* ~ 2 5 mV rms to 200 MHz
42 mV rrns to 300 MHz
+ 3 d B a t ~ 1 0 0 k H z + 3 d B a t ~ 1 6 H z
~ 7 0 mV p-p pulse ~ 7 0 mV p-p pulse
(<200 MHz)
~ 1 2 5 mV rms* ~ 1 2 5 mV rms to 200 MHz
21 0 mV rrns to 300 MHz
+ 3 d B a t ~ 1 0 0 k H z + 3 d B a t ~ 1 6 ' ~ z
~ 3 5 0 mV p-p pulse ~ 3 5 0 mV p-p pulse
( ~ 2 0 0 MHz)
+2% of reading for a dc input voltage
+
40 mVx atten.
1
MQ performance is from a
25 Q source impedance.
Typical sensitivity is 50 mV p-p
+20 mV.
70 mV p-p to 4 V p-p
350 mV p-p to 20 V p-p
n approximately 4 mV steps.
n approximately 20 ml V steps.
rrigger level is calibrated
n
+
slope and is firm,ware
:ompensated in
-
slc~pe.
*O°C to 40°C; sensitivity decreases by 31 % for 40°C to 50°C.
REV JUL 1983