Assembling The Model; A) Wings - Reely Piper J3 Cub Bedienungsanleitung

8.

Assembling the Model

Before assembling the model, please read each individual section carefully. The construction stages are
almost always illustrated for better understanding.
Please note that the numbers in the text always refer to the components in the illustration to the right.
For design and colouration of the model, you may use the figure on the packaging as reference. Design and
colour deviations in these operating instructions are possible. The figures in these operating instructions
only serve illustration.
Only carry out the steps described in the different sections if you have completely understood the procedure
and know exactly what to observe.
The model is only suitable for a combustion engine and a strong electric drive. Installation must be per-
formed at your own discretion according to the engine used.
Accessories required for motor installation is not enclosed with the construction kit and must be purchased
separately depending on the drive used.
For notes on recommended motor sizes, see chapter „Technical Data" at the end of these operating instruc-
tions.

a) Wings

Open the receptacles for the wing plug con-
nection (1) at the ribs of the wing, the openings
of the servo cables (2), the wing screws (3) and
the arresting dowels (4)..
Feel for the pre-frilled holes in the cut-out area
of the wing and open them with a cutter knife.
Insert the dowels drily and check the correct
position of the dowels with the wings installed.
When everything is sitting perfectly, the dowels
may be glued in at a later time. Adhesive resi-
due must be removed immediately.
34
Figure 1