Reely Piper J3 Cub Bedienungsanleitung Seite 47

When the model is flying along the planned landing line, reduce the motor speed further or turn off the motor comple-
tely, and keep the model in a horizontal position using the elevator. The model now should lose height and fly towards
the planned touch-down point at the end of the imagined landing line.
In this critical flying phase, ensure sufficient flying speed and do not slow down the model reducing the motor speed
too much or by pulling too hard at the elevator.
Slightly move the elevator briefly before touchdown.
After landing, adjust the linkage rods so that the airplane flies straight and ensure that the trimming on the transmitter
are in the central position again.
Once you are able to handle the airplane perfectly, you can try to optimise its flight by shifting the balance point.
47