Setting Up The Model Helicopter; A) Charging The Helicopter Rechargeable Battery - Reely 2115097 Bedienungsanleitung

10. Setting up the model helicopter

a) Charging the helicopter rechargeable battery

The built-in helicopter rechargeable battery can be charged either via the transmitter or via the supplied USB cable.
The charging time is approx. 30 to 45 minutes depending on the amount of residual charge of the helicopter recharge-
able battery.
Charging via transmitter:
While charging, the transmitter must be switched off. The
on/off switch on the underside of the model helicopter (1)
must be in the upper position (OFF).
Slide the charging cable compartment cover (2) down
slightly and ip the cover open.
Remove the charging plug (3) and pull out the charging
cable (4) to the required length.
Insert the charging plug into the charging socket of the
helicopter (5). The charging socket is located on the un-
derside of the helicopter just next to the on/off switch (1).
A red LED (6) lights up inside the model helicopter, which
signals the charging process.
Once the helicopter rechargeable battery is fully charged,
the charging control LED on the model helicopter will go
out.
After charging, the charging plug must be disconnected
from the helicopter. Slide the charging cable back into the
transmitter and close the charging cable compartment
cover.
If you want to charge the helicopter recharge-
able battery via the transmitter, be sure not to
insert NiMH or NiCd rechargeable batteries into
the transmitter.
The helicopter rechargeable battery cannot be
charged properly due to the too low transmit-
ter voltage (batteries = 1.5 V/cell, rechargeable
batteries = 1.2 V/cell)!
32
Figure 4