Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3
Display during operation
Fig. 4.3
The information on the measurements and the status messages depend on the unit's
NOTE
configuration!
4.4
Status messages
Abb. 4.4
Abb. 4.5
Abb. 4.6
Abb. 4.7
Abb. 4.8
Abb. 4.9
Abb. 4.10
Abb. 4.11
Abb.4.12
Abb.4.13
Abb.4.14
Abb.4.15
Abb.4.16
417101386_AquantaControl_II.doc
The display information continually revolves
between the unit version (A) with the date
and time and the configured measurements
(B) with the status messages.
Pos
If the detergent release is locked, a hash sign is shown on the
display (pos. 1).
In normal metering operation with detergent release, the hash
sign disappears (fig. 4.4, pos. 1) and a triangle (pos. 2) appears
on the display as soon as the detergent metering pump is
activated.
If pre-metering is activated, a diamond (pos. 3) is displayed
during the pre-metering period.
If a pre-metering delay period has been configured, an up and
down arrow (pos. 4) is displayed during the delay period rather
than the diamond (fig. 4.6, pos. 3).
If additive metering is activated, an up arrow (pos. 5) is displayed
during the metering process. Additive metering is only possible in
conjunction with detergent 1!
A square frame (pos 6) is displayed if the flushing release is
available.
On activating the rinsing pump, the frame (pos. 7) is filled in.
If automated zero-point suppression is activated, the code 'ZC'
(pos. 8) is displayed during the zero-point suppression process.
If a crate counter is connected and detects a crate, a pulse
symbol (pos. 9) is displayed for approx. three seconds.
The '!' (pos. 10) after the conductivity measurement indicates an
active zero-point suppression process.
The uncompensated conductivity value can be displayed by
pressing the ENTER-key (↵). A '*' (pos. 11) is displayed after the
conductivity value.
In the proportional metering mode, a 'P' (pos. 12) appears on the
display (conductivity value is hidden).
In the proportional metering + conductivity mode, a 'P' (pos. 12)
appears on the display in front of the conductivity value (pos. 12).
The active detergent is only displayed in the top left (D1 or D2)
(pos. 14) when detergent 2 metering is activated.
- 60 -
Description
1
Summer time
2
Date
3
Unit version
4
Time
Rev. 4-2/10
Werbung
Inhaltsverzeichnis
