Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
Parameter Assignment Level
The parameters can also be entered and transmitted on the PC in connection with the
NOTE
"AquantaGet" PC software.
Depending on the configuration, at parameter assignment level (PARAMETER
FUNCTIONS)
• the adjustment and calibration functions can be called (ADJUSTMENT FUNCTIONS) for
the detergent 1 metering unit (DETERGENT 1 DOS.)
-
the detergent 2 metering unit (DETERGENT 2 DOS.)
-
the rinse aid metering unit (RINSE AID DOS.)
-
the additive metering unit (ADDITIVE DOS.)
-
the water meter pulse rate (COMPARISON WATER METER → PULSE RATE WZ1 AND WZ2)
-
the conductivity cell (ZERO CALIBRATION CONDUCT. SENSOR) (ADJUSTMENT
-
CONDUCTIVITY)
the washing tank temperature (TANK)
-
the rinsing water temperature (RINSE AID)
-
the dry zone temperature (DRY ZONE)
-
• all metering settings can be made (DEFINE METERING SETTINGS)
SETTINGS DETERGENT 1 DOS
-
the pre-metering time (PRE METERING TIME)
-
the pre-metering concentration (PRE-METERING CONC.) only in proportional operation.
-
the delay time for the pre-metering start (PRE-METERING DELAY)
-
the concentration in normal mode (DETERGENT CONC.)
-
the concentration of the booster stage (BOOSTER CONC.)
-
the temperature compensation can be adapted to the used product.
-
(TEMPERATUR COMP. ALKALI 1 / ALKALI 2 / ACID 1 / ACID 2).
SETTINGS DETERGENT 2 DOS (only with configuration)
-
Settings just as detergent 1
-
the concentration for the additive (ADDITIVE CONC.) only in proportional operation.
-
• the fault message settings can be made (ALARM CONTROL SETUP)
−
SETTINGS DETERGENT 1 DOS
−
the delay time for detergent empty report (EMPTY DETERGENT DELAY)
−
the max. metering time limit (DETERGENT DELAY TIME)
−
the concentration, priority and delay time for detergent over-metering
(DET. OVERDOSAGE CONZ / ONLY MEMORY / DELAY:)
−
SETTINGS DETERGENT 2 (only with configuration)
−
Settings just as detergent 1
−
the delay time for rinse aid empty report (EMPTY RINSE AID DELAY)
−
the delay time for additive empty report (EMPTY ADDITIVE DELAY)
−
SETTINGS WASH TEMPERATURE
−
the thresholds for LOW and HI, priority and delay time
(TEMPERATURE LOW / HI / MEMORY ONLY/ DELAY)
−
SETTINGS RINSE TEMPERATURE (only with configuration)
−
just as wash temperature
−
SETTINGS DRY ZONE TEMP (only with configuration)
−
just as wash temperature
−
aktivate the alarm repeat (ALARM REPEAT)
• date and time setting can be made (TIME/DATE SETUP)
setting of time and date (TIME/DATE)
-
setting of automatic summer time switching (SUMMER TIME AUTOMATIC ? ON).
-
• the data memory can be deleted (DELETE FUNCTIONS)
delete the fault message memory (DELETE FAULT MESSAGES)
-
delete the consumption data memory (DELETE STATISTIC VALUES), and reset all parameters
-
to the ex-works setting (DELETE PARAMETER SETTING).
The programming steps and display texts listed in the following sections of this chapter are
NOTE
summarized in the overview
417101386_AquantaControl_II.doc
"Programming Overview "Aquanta-Control
- 65 -
II".
Rev. 4-2/10
Werbung
Inhaltsverzeichnis
