Setting Time And Date; Setting The Automatic Summer Time Switching; Delete Functions; Deletion Of The Fault Message Report - ECOLAB AQUANTA CONTROL II Bedienungsanleitung

6.6.1

Setting time and date

To set the date and time:
1. Activate the TIME/DATE SETUP menu.
2. Activate the TIME/DATE menu.
3. Set the current time and the current date.
Move the cursor to the desired position with the ENTER- key for this.
Set the current value with the upper-key or down-key.
4. Press the NEXT key to confirm.
6.6.2

Setting the automatic summer time switching

To set the automatic summer time switching:
1. Activate the TIME/DATE SETUP menu.
2. Activate the AUTOMATIC SUMMER TIME menu.
3. Select between ON and OFF by pressing the upper-key or down-key.
4. Press the NEXT key to confirm.
6.7

Delete Functions

The delete functions can also be transmitted by the PC in connection with the
NOTE
"AquantaGet" PC software.
With the DELETE FUNCTIONS menu the fault message report can be deleted, the
consumption data statistics reset to zero and all parameters reset to their ex-works settings.
The security prompt ARE YOU SURE? appears before the actual deletion or resetting and
the intended deletion must be confirmed by switching from NO to YES. Only then are the
data actually deleted or reset.
6.7.1

Deletion of the fault message report

To delete the logged data:
1. Activate the DELETE FUNCTIONS menu.
2. Activate the DELETE FAULT MESSAGES menu.
3. Switch from NO to YES by pressing one of the upper-key or down-key, if all the recorded
fault messages are to be deleted.
6.7.2

Resetting the consumption statistics

To reset the consumption statistics (delete the recorded statistical values):
1. Activate the DELETE FUNCTIONS menu.
2. Activate the DELETE STATISTIC VALUES menu.
3. Switch from NO to YES by pressing one of the upper-key or down-key, if the statistics
memory is to be reset to zero.
6.7.3

Resetting all parameters

To reset all parameters to their standard values
1. Activate the DELETE FUNCTIONS menu.
2. Activate the DELETE PARAMETER SETUP menu.
Switch from NO to YES by pressing one of the upper-key or down-key, if all the parameter
values are to be reset.
417101386_AquantaControl_II.doc - 76 - Rev. 4-2/10