Operation Modes - ECOLAB Lubo-DryExx Advanced Betriebsanleitung

7.3.7.1.1

Operation modes

fig. 7.20
After leaving the picture with button „Back" you see again the „General Parameters".
7.3.7.1.2 Monitoring
fig. 7.21
7.3.7.1.3 Unit counter
fig. 7.22
After leaving the picture with button „Back" you see again the „General Parameters".
All system attitudes are exclusively alterable by technical personnel and are not more
NOTE
near described.
417101634_Lubo-DryExx_Advanced
The display contains the following announcements:
• Active operation mode
• To change operation mode
 Press desired operation mode button
 Switch on control dosing amount
• To leave "Operation mode"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press " "
The display contains the following announcements:
• Actual metering value
• Desired metering value
• Metering deviation positive [%]
• Metering deviation negative [%]
• Metering value positive [%]
• Metering value negative [%]
• To the other valves (metering circuits)
 Press „" Button
 Press „" Button
• To configure the desired metering value
 Press „"
OR
• To go to the 'Start' screen:
 Press " "
The display contains the following announcements:
• Pulse width of optional unit counter/area
• To change pulse width
 Press button for desired area „units per puls"
• To leave "Unit counter"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press " "
- 47 - Rev. 07-01.15