Packaging - Abicor Binzel iCAT Betriebsanleitung

iCAT
12 Disposal
12.1 Materials
12.2 Consumables

12.3 Packaging

13 Appendix
Accessories: pull-in tool
4 Disconnect torch neck and remove it.
 6.6 Attaching the ABIROB
 6.7 Attaching the ABIROB
 6.8 Attaching the ABIROB
 6.9 Attaching the ROBO WH torch neck on page EN-22
5 Dismount the iCAT (1) from the robot (4).
 6.2 Fastening the iCAT to the robot on page EN-12
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the product to be properly disposed of, it first must be
dismounted.
 11 Dismounting on page EN-30
This product is mainly made of metallic materials which can be molten in steel
and iron works and are thus almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
Oils, greases and cleaning agents must not contaminate the ground and not
enter sewage systems. These materials must be stored, transported and
disposed of in suitable containers. Please observe the relevant local regulations
and disposal instructions of the safety data sheets given by the manufacturer of
the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the
manufacturer of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
The pull-in tool serves for the correct mounting of cable assemblies. The O-rings
at the rod of the pull-in tool indicate the mounting positions of the cable
assembly versions ABIROB
in tool must only be used for the iCAT robot mount.
®
A torch neck on page EN-19
®
W torch neck on page EN-20
®
GC torch neck on page EN-21
® ®
A, ABIROB W and ABIROB
12 Disposal
®
GC. The pull-
EN - 31