Abicor Binzel iCAT Betriebsanleitung Seite 62

11 Dismounting
Fault Cause
Inaccurate torch • Dirt deposits in the housing
reset
• iCAT damaged
Gas loss • Liner diameter too large
• Liner insufficiently stripped on the torch
Tab. 15 Troubleshooting
11 Dismounting
EN - 30
side
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power supply.
• Cut off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTICE
• Disassembly may only be carried out by qualified personnel (in
Germany see TRBS 1203).
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-23.
1 Disconnect the cable assembly (2) from the wire feeder (1) .
 Fig. 9 Axis positions on page EN-17
ABIROB
Versions
2 Unscrew threaded sleeve (2) and bellows (3), remove fastening
screw (14).
 Fig. 8 Mounting the ABIROB
page EN-15
ROBO
Version WH:
 Fig. 10 Mounting the ROBO WH cable assembly on page EN-18
3 Pull cable assembly (2) out of the iCAT and remove it through the 4th axis
of the robot toward the back.
 Fig. 9 Axis positions on page EN-17
Solution
• Remove dirt deposits, clean housing
• Verification by qualified personnel
• Use a smaller liner
• Strip liner 350 mm on the torch side
®
A, GC, W:
®
A, GC, W cable assembly on
iCAT