Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel iCAT Betriebsanleitung

iCAT
7 Operation

8 Putting out of operation

9 Maintenance and cleaning

NOTICE
• The device may only be operated by qualified personnel (in Germany
see TRBS 1203).
Due to the fact that the iCAT is integrated into the welding process of the torch,
the operating steps are performed after the respective torch has been put into
operation. Please observe the operating instructions of the respective
®
ABIROB A, ABIROB
NOTICE
• Please make sure that the shutdown procedures for all components
mounted in the welding system are strictly observed before putting out of
operation begins.
Putting out of operation depends on the respective welding torch.
Please observe the operating instructions of the respective ABIROB
®
ABIROB GC, ABIROB
Regular and lasting maintenance and cleaning are the prerequisite of a long
life and a trouble free operation.
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power supply.
• Close off the compressed air supply.
• Pull the mains plug.
® ®
GC, ABIROB W, ROBO WH welding torches.
®
W, ROBO WH welding torches.
7 Operation
®
A,
EN - 23