Packaging - Abicor Binzel iCAT mini ABIROB G Betriebsanleitung

11 Disposal
11 Disposal
11.1 Materials
11.2 Consumables

11.3 Packaging

EN - 20
®
G350 versions:
ABIROB
2 Unscrew protection cap (1) and bellows (2),
Loosen the fastening screw (5).
 Fig. 9 Fastening the ABIROB
3 Disconnect the torch neck and remove it.
 6 Operation on page EN-15
4 Remove iCAT mini (1) from robot(4).
 5.2 Mounting the iCAT mini on the robot on page EN-12
For disposal, observe the local regulations, laws, provisions, standards and
guidelines. Observe the guidelines for the disposal of electronic scrap and
dispose of it at your communal waste disposal authorities (e.g. recycling yard).
For the product to be properly disposed of, it first must be dismounted. Observe
the following information:
 See 10 Disassembly on page EN-19
This product is mainly made of metallic materials which can be melted in steel
and iron works and are, thus, almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
Oil, greases and cleaning agents must not contaminate the ground or enter
sewage systems. These materials must be stored, transported and disposed of
in suitable containers. Observe the relevant local regulations and disposal
instructions of the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABICOR BINZEL has reduced the shipping packaging to the minimum
possible. Packaging materials are always selected with regard to their possible
recycling ability.
®
torch neck on page EN-14
iCAT mini