Packaging - Abicor Binzel iCAT mini Betriebsanleitung

iCAT mini
11.4 Disassembling iCAT mini with welding torch neck ABIROB
(iCAT mini with wire brake)
1 Disconnect the cable assembly from the wire feeder.
2 Remove the plastic tube (4) from the wire brake (3).
3 Unscrew the wire brake (3).
4 Disconnect the welding torch neck and remove it.
5 Remove the protective cap (1) and the bellows (2).
 Fig. 18 Cleaning – iCAT mini with wire brake and welding torch neck ABIROB
page EN-30
6 Loosen the cable assembly and remove it.
 Fig. 7 Mounting the cable assembly iCAT mini for ABIROB
7 Disassemble the iCAT mini (1) from the robot (7).
Fig. 5 Attaching the iCAT mini to the robot on page EN-16
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines
must be observed. To correctly dispose of the product, it must first be disassembled.
Please note the following information:
 11 Disassembly on page EN-33
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and
are thus almost infinitely recyclable. The plastic materials used are labeled in preparation for
their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system.
These substances must be stored, transported and disposed of in suitable containers. Observe
the relevant local regulations and disposal instructions in the safety data sheets specified by the
manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability
to recycle packaging materials is always considered during their selection.
BAL.0361.0 • 2021-02-25
12 Disposal
®
W
®
W on
®
G on page EN-17
EN - 35