Abicor Binzel iCAT Betriebsanleitung Seite 52

6 Putting into operation
6.7 Attaching the ABIROB
1
®
1 ABIROB W torch neck
2 Positioning pin
Fig. 12 Attaching the ABIROB
EN - 20
1 Equip the ABIROB
gas nozzle.
 Instruction leaflet BEI.0068.
®
2 Insert ABIROB A torch neck (1) via the guide grooves into the iCAT
®
ABIROB A (3) as far as it will go.
3 Tighten the set screws (4) with a hexagon wrench (2). Tightening torque
M= 2.5 Nm.
®
W torch neck
3 iCAT ABIROB
®
W torch neck
®
1 Equip the ABIROB
nozzle.
2 Introduce positioning pin (2) into marked bore.
®
The ABIROB W torch neck (1) can only be fastened in this position.
3 Screw down ABIROB
®
iCAT ABIROB W (3).
NOTICE
• After using the torch for several days, it may happen that it cannot be
disconnected by hand. To do this, a suitable wrench is available. Do not
use pliers to disconnect the torch.
®
A torch neck (1) with a tip adaptor, contact tip and
2
®
W 4
W torch neck (1) with tip adaptor, contact tip and gas
®
W torch neck (1) with retaining nut (4) on the
3
4
Retaining nut
iCAT