Abicor Binzel iCAT Betriebsanleitung Seite 59

iCAT
9.3 Cleaning the iCAT ABIROB
1
1 Retaining ring
2 Bellows
Fig. 17 Cleaning the iCAT ABIROB
7 Grease the O-rings (6), (5) with sealing grease (included in the scope of
delivery).
8 Mount the O-rings (6), (5) onto the compression sleeves (7).
9 Mount the balls (9), compression springs (8) and compression sleeves (7).
10Dismount the set screw (3) and gas duct (2) and check them, if necessary
replace them.
11 Reinstall the fastening screw (12), washer (11) and screw (10).
12 Mount bellows (14) and retaining ring (13).
®
GC
3 iCAT ABIROB
4 Fastening screw
®
GC
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in
particular safety goggles.
1 Clean the iCAT ABIROB
2 Pull off retaining ring (1) and bellows (2) and clean with compressed air.
3 Remove screw (5), washer (6) and fastening screw (4) and clean them
together with compressed air.
4 Blow compressed air through the bores.
5 Reinstall the screw (4), washer (6) and screw (5).
9 Maintenance and cleaning
2
6
®
GC 5 Screw
6 Washer
®
GC (3) with compressed air.
3
4
5
EN - 27