Packaging - Abicor Binzel CAT3Pro Serie Betriebsanleitung

CAT3Pro
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines
must be observed. Observe the regulations on the disposal of electronic scrap and dispose of
it at your local waste disposal site (e.g. recycling center).
To correctly dispose of the product, it must first be disassembled. Please note the following
information:
 11 Disassembly on page EN-21
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and
are thus almost infinitely recyclable. The plastic materials used are labeled in preparation for
their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system.
These substances must be stored, transported and disposed of in suitable containers. Observe
the relevant local regulations and disposal instructions in the safety data sheets specified by the
manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability
to recycle packaging materials is always considered during their selection.
BAL.0843.0 • 2020-11-03
12 Disposal
EN - 23