Abicor Binzel iCAT Betriebsanleitung Seite 46

6 Putting into operation
1 Robot
Fig. 7 Mounting the corrugated hose clamp
6.4 Mounting the hose assembly on the robot
EN - 14
1
3
2 2 cylinder screws M6x25
1 Fasten corrugated hose clamp (2) loosely to the robot (1) with cylinder
screws (2) such that a gap of approx. 5 mm between between the clamp
halves is formed.
NOTICE
• When mounting liquid-cooled ABIROB
assemblies, make sure that the mounting bores for the water nipples and
the O-rings are lubricated.
• When mounting liquid-cooled ABIROB
assemblies, make sure that the water nipples in the welding torch
coupling ABIROB
cable assembly adapter. Observe the forced positioning.
• After mounting is complete, check for any leaks.
• When mounting liquid- and air-cooled cable assemblies, make sure that
all lines (control cable, water hoses, gas/compressed air lines) are
installed without torsion and with sufficient clearance.
2
3 Corrugated hose clamp
®
®
®
W and ROBO WH are inserted correctly into the
W and ROBO WH cable
W and ROBO WH cable
iCAT