Putting Out Of Operation; Maintenance And Cleaning; Maintenance Intervals - Abicor Binzel CAT3Pro Serie Betriebsanleitung

8 Putting out of operation

8 Putting out of operation
NOTICE
• Consult the documentation for the welding components.
Decommissioning depends on the respective welding torch.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free
operation. During such activities, observe the following:
DANGER
Risk of injury due to unexpected start
Improper operation can lead to serious injuries that could result in death.
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the gas supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Check and wear your personal protective equipment.

9.1 Maintenance intervals

NOTICE
• The specified maintenance intervals are standard values and refer to single-shift
operation.
EN - 18
CAT3Pro
BAL.0843.0 • 2020-11-03