HP ProLiant Gen8 Handbuch Seite 5

Logical Drive X Status = Wrong Drive Replaced ............................................... 12
Loose Cable Detected - Logical Drives May Be Marked FAILED Until
Corrected .......................................................................................................... 12
Mirror Data Miscompare .................................................................................... 13
No Configuration for Array Accelerator Board ................................................... 13
One or More Drives is Unable to Support Redundant Controller Operation ..... 13
Other Controller Indicates Different Hardware Model ....................................... 13
Other Controller Indicates Different Firmware Version ..................................... 13
Other Controller Indicates Different Cache Size ............................................... 13
Processor Reduced Power Mode Enabled in RBSU ........................................ 14
Processor Not Started (Processor Stalled) ....................................................... 14
Processor Not Started (Stepping Does Not Match) .......................................... 14
Processor Not Started (Unsupported Processor Stepping) .............................. 14
Processor Not Supported (Unsupported Core Speed) ...................................... 14
RIS Copies Between Drives Do Not Match ....................................................... 14
SCSI Port X Drive ID Y Failed - REPLACE (failure message) .......................... 14
SCSI Port X, Drive ID Y Firmware Needs Upgrading ....................................... 14
SCSI Port X, Drive ID Y Has Exceeded the Following Threshold(s) ................. 15
SCSI Port X, Drive ID Y is not Stamped for Monitoring .................................... 15
SCSI Port X, Drive ID Y May Have a Loose Conncetion... ............................... 15
SCSI Port X, Drive ID Y RIS Copies Within This Drive Do Not Match .............. 15
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been
Detected in the Factory Monitor and Performance Data... ................................ 15
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been
Detected in the Power Monitor and Performance Data... .................................. 16
SCSI Port X, Drive ID Y Was Replaced On a Good Volume: (failure
message) .......................................................................................................... 16
Set Configuration Command Issued ................................................................. 16
Soft firmware upgrade required ......................................................................... 16
Storage Enclosure on SCSI Bus X has a Cabling Error (Bus Disabled)... ........ 16
Storage Enclosure on SCSI Bus X Indicated a Door Alert... ............................. 16
Storage Enclosure on SCSI Bus X Indicated a Power Supply Failure... ........... 16
Storage Enclosure on SCSI Bus X Indicated an Overheated Condition... ........ 17
Storage enclosure on SCSI Bus X is unsupported with its current firmware
version... ............................................................................................................ 17
Storage Enclosure on SCSI Bus X Indicated that the Fan Failed... .................. 17
Storage Enclosure on SCSI Bus X Indicated that the Fan is Degraded... ........ 17
Storage Enclosure on SCSI Bus X Indicated that the Fan Module is
Unplugged... ...................................................................................................... 17
Storage Enclosure on SCSI Bus X - Wide SCSI Transfer Failed... ................... 17
Swapped cables or configuration error detected. A configured array of
drives... .............................................................................................................. 18
DEWW v