HP ProLiant Gen8 Handbuch Seite 221

Protokolltyp: LOG_CRIT, Fehlertyp: HW
OA Tray firmware upgrade failed.
OA: Blade in bay [value:bladeNumber] contains an unsupported #[value]
mezz card.
OA: Enclosure Status changed from [N/A/Unknown/OK/Degraded/Failed] to [N/
A/Unknown/OK/Degraded/Failed].
OA: Failed to initialize key components. Please call support immediately.
OA: Fan [value] firmware upgrade failed.
OA: Interconnect [value:slotNumber] firmware upgrade failed.
OA: Interconnect [value] firmware upgrade failed.
OA: LCD fails to respond to keystrokes.
OA: LCD firmware upgrade failed.
OA: LCD not functioning properly, pausing operation for 10 seconds.
OA: LCD Status is: Failed
OA: mgmt: GPIO initialization failed.
OA: mgmt: i2c initialization failed.
OA: Mismatching I/O was detected on Blade [value:bladeNumber],
interconnect [value].
OA: Mismatching I/O was detected on Blade [value:bladeNumber], Mezzanine
Card [value], Port [value].
OA: Mismatching I/O was detected on Interconnect [value], Port [value].
OA: Temperature of I/O module in slot [value:slotNumber] is critical -
module shut down
OA: Unsupported Device in bay #[value:bladeNumber].
OA: Unsupported IO Module in bay #[value:slotNumber].
OA: Unsupported IO Module location in bay #[value:slotNumber].
Protokolltyp: LOG_CRIT, Fehlertyp: SW
OA: Blade [value:bladeNumber] management processor firmware upgrade
failed.
OA: Error reading Fru Board Info for the LCD.
OA: Error reading Fru information for the LCD.
OA: Error reading Fru Internal Use Area for the LCD.
OA: mgmt: Failed to acquire enclosure semaphore.
Protokolltyp: LOG_CRIT, Fehlertyp: Info
OA: Mismatching I/O condition resolved, Blade [value:bladeNumber],
interconnect [value] was removed.
OA: Mismatching I/O was removed on Blade [value:bladeNumber], Mezzanine
Card [value], Port [value].
DEWW SysLog-Meldungen 197