HP ProLiant Gen8 Handbuch Seite 7

Array Accelerator: The cache is disabled because the charge on the flash-
memory capacitor is too low .............................................................................. 24
Array Accelerator: The cache is disabled because a capacitor has failed to
charge to an acceptable level ........................................................................... 24
Array Accelerator: The cache is disabled because the backup operation to
flash memory failed ........................................................................................... 24
Array Accelerator: The cache is disabled because there are no capacitors
attached to the cache module ........................................................................... 24
Array Accelerator: The cache is disabled because a flash memory or
capacitor hardware failure has been detected .................................................. 24
Array Accelerator: This controller's firmware is not backward compatible
with the cache module revision ......................................................................... 24
Array status: The array has failed ..................................................................... 24
Array status: The array currently has a drive erase operation queued,
running, stopped or completed on a logical or physical drive ........................... 24
Array status: The array has a spare drive assigned which is smaller than
the smallest data drive in the array... ................................................................ 24
Controller State: The array controller contains a volume that was created
with a different version of controller firmware... ................................................ 24
Controller State: The array controller contains more logical drives than are
supported in the current configuration... ........................................................... 25
Controller State: The array controller contains one or more logical drives
with a RAID level that is not supported in the current configuration... .............. 25
Controller State: The array controller contains redundant connections to
one or more physical drives that are not supported in the current
configuration... .................................................................................................. 25
Controller State: The array controller is connected to an expander card or
an external enclosure... .................................................................................... 25
Controller State: The array controller is operating without a memory
board... ............................................................................................................. 25
Controller State: The array controller is operating without a memory board
and has a bad volume position... ...................................................................... 26
Controller State: The array controller is operating without a memory board
and contains more logical drives than are supported in the current
configuration... .................................................................................................. 26
Controller State: The array controller is operating without a memory board
and has an invalid physical drive connection... ................................................ 26
Controller State: The array controller has a configuration that requires more
physical drives than are currently supported... ................................................. 26
Controller State: The array controller has an unknown disabled
configuration status message... ........................................................................ 26
Controller State: The array controller has an unsupported configuration... ...... 26
Controller State: The controller cannot be configured. CACHE STATUS
PROBLEM DETECTED:... ................................................................................ 27
DEWW vii