Meldungen Des Permanenten Konfigurationsprotokolls - HP ProLiant Gen8 Handbuch

Enclosure-Link: Calling getEvent
Enclosure-Link: Device attached on lower interface
Enclosure-Link: Device attached on upper interface
Enclosure-Link: Device attached/detached but no topology changes detected
Enclosure-Link: Device detached on lower interface
Enclosure-Link: Device detached on upper interface
Enclosure-Link: Doing elink topology scan now
Enclosure-Link: Found new elink topology. Notifying subsystems
Enclosure-Link: Found new Topology: [value] enclosure added to chain
([value] total)
Enclosure-Link: Found new Topology: [value] enclosure removed from chain
([value] total)
Enclosure-Link: Found new Topology: New enclosure connected ([value]
total)
Enclosure-Link: Got new TOPOLOGY event on enclosure [value:IpAddress]
Enclosure-Link: Initial topology scan completed successfully
Enclosure-Link: Service started

Meldungen des permanenten Konfigurationsprotokolls

Protokolltyp: LOG_WARNING, Fehlertyp: SW
CLI: Error accessing User Configuration Files
Protokolltyp: LOG_ERR, Fehlertyp: SW
envtools: Block [value] failed encoding
envtools: Error in default gateway
envtools: Error in DNS1 address
envtools: Error in DNS2 address
envtools: Error in ipaddress
envtools: Error in ipAllow1 address
envtools: Error in ipAllow2 address
envtools: Error in ipAllow3 address
envtools: Error in ipAllow4 address
envtools: Error in ipAllow5 address
envtools: Error in ipv6Dns1 address
envtools: Error in ipv6Dns2 address
envtools: Error in ipv6StaticAddress1 address
envtools: Error in ipv6StaticAddress2 address
DEWW SysLog-Meldungen 183