HP ProLiant Gen8 Handbuch Seite 130

Schweregrad: Warnung
Protokollmeldung: The <drive type> physical drive located in bay <bay number>
is offline but operational. This drive can be found in box <box number>
which is connected to port <port number> of the array controller
<controller name / slot information>. The offline reason received from
the HP Smart Array firmware is: <firmware error code>.
<firmware error code>-Werte:
●
TOO_SMALL_IN_LOAD_CONFIG - Replacement drive is too small for
configured volume(s).
●
ERROR_ERASING_RIS - Could not write to reserved configuration sectors
after multiple retries.
●
ERROR_SAVING_RIS - Could not write to reserved configuration sectors
after multiple retries.
●
FAIL_DRIVE_COMMAND - "Fail Drive" command received from host.
●
MARK_BAD_FAILED - Unable to create media defect after multiple retries.
●
MARK_BAD_FAILED_IN_FINISH_REMAP - Unable to create media defect after
multiple retries.
●
TIMEOUT - Too many SCSI command timeouts.
●
AUTOSENSE_FAILED - Drive is failing commands but is not returning SCSI
sense data after multiple retries.
●
MEDIUM_ERROR_1 - Caused by a particular set of SCSI sense codes that
indicate the drive is in bad shape and its data may be corrupt.
●
MEDIUM_ERROR_2 - Caused by a particular set of SCSI sense codes that
indicate the drive is in bad shape; retries did not help.
●
NOT_READY_BAD_SENSE - Drive is returning unrecognized Not Ready sense
codes.
●
NOT_READY - Drive is not ready and will not spin up.
●
HARDWARE_ERROR - Drive is returning a Hardware Error sense key;
controller unable to get drive back online.
●
ABORTED_COMMAND - Drive is returning an Aborted Command sense key;
controller unable to get drive back online.
●
WRITE_PROTECTED - Drive is returning a sense key indicating it is
write protected.
●
SPIN_UP_FAILURE_IN_RECOVER - "Start Unit" command failed during error
recovery
●
REBUILD_WRITE_ERROR - Drive failed write command after multiple
retries during rebuild.
●
TOO_SMALL_IN_HOT_PLUG - Replacement drive is too small for configured
volume(s).
●
BUS_RESET_RECOVERY_ABORTED - Unable to communicate with drive after
multiple bus resets and retries; may be due to this drive or another
drive that is corrupting the parallel SCSI bus.
106 Kapitel 3 HP Smart Array-Fehler DEWW