HP ProLiant Gen8 Handbuch Seite 227

OA: Midplane replacement detected. Serial number changed from [value] to
[value].
OA: Mixing 400Hz PSs with other PSs is not supported
OA: Power Limit Set To: [value]
OA: Power Limit Set To: Not Set
OA: Power Subsystem Redundancy Mode Set To: [N+N/N+1/N+0/]
OA: Power Supplies Connected To Both AC and DC Input Lines: REPAIRED
OA: PS Inserted: Bay #[value]
OA: PS Subsystem N + 1 Redundancy - REPAIRED
OA: PS Subsystem N + 1 Redundancy Power Limit - REPAIRED
OA: PS Subsystem N + N Redundancy - REPAIRED
OA: PS Subsystem N + N Redundancy Power Limit - REPAIRED
OA: PS Subsystem Overloaded - REPAIRED
OA: PS Subsystem Power Limit - REPAIRED
OA: Redundant Onboard Administrator was inserted
OA: Server Power Reduction - Activated
OA: Server Power Reduction Mode - Disabled
OA: Server Power Reduction Mode - Enabled
OA: Server Power Reduction Mode - Enabled
OA: TRAY microcode updated from UNKNOWN version to version [value:version]
OA: TRAY microcode updated from version [value:version] to version
[value:version]
Protokolltyp: LOG_INFO, Fehlertyp: HW
OA: Interconnect removed from bay [value:slotNumber]
Protokolltyp: LOG_INFO, Fehlertyp: SW
OA: A [CD/DVD/USB Key] was inserted into the Onboard Administrator.
OA: A [CD/DVD/USB Key] was removed from the Onboard Administrator.
OA: A [CD/DVD/USB Key] was unmounted from the Onboard Administrator.
OA: Blade [value:bladeNumber]: Mezz card internal data problem for
[value].
OA: Failed to mount [CD/DVD/USB Key]: [value:errorCode]
OA: Failed to mount [CD/DVD/USB Key][value]: unsupported filesystem.
OA: Interconnect inserted in bay [value:slotNumber]
OA: VC module in interconnect bay [value:slotNumber] has firmware
revision [value:version] but minimum firmware revision [value:version] is
required
DEWW SysLog-Meldungen 203