HP ProLiant Gen8 Handbuch Seite 177

●
INIT_RESET_RECOVERY_ABORTED - Unable to communicate with drive during
initialization after multiple bus resets and retries; may be due to
this drive or another drive that is corrupting the parallel SCSI bus.
●
DEFERRED_WRITE_ERROR - Drive with write cache enabled reported that it
could not complete a write command that it previously indicated was
successful [lost data].
●
MISSING_IN_SAVE_RIS - Could not write to reserved configuration
sectors after multiple retries.
●
WRONG_REPLACE - A hot-plug tape drive was plugged in as a replacement
into a drive bay that a hard disk was removed from.
●
GDP_VPD_INQUIRY_FAILED - Could not read drive serial number after
multiple retries.
●
GDP_MODE_SENSE_FAILED - Could not read certain mode pages after
multiple retries.
●
DRIVE_NOT_IN_48BIT_MODE - SATA drive is not supported in 48-bit LBA
mode.
●
DRIVE_TYPE_MIX_IN_HOT_PLUG - Attempt to hot-add a SATA drive as a
replacement in a SAS-only volume, or vice versa.
●
DRIVE_TYPE_MIX_IN_LOAD_CFG - attempt to use a SATA drive as a
replacement in a SAS-only volume, or vice versa.
●
PROTOCOL_ADAPTER_FAILED - Protocol layer reports that the protocol
hardware has failed; may be a controller failure.
●
FAULTY_ID_BAY_EMPTY - Drive responds to SCSI ID, but the corresponding
bay is empty.
●
FAULTY_ID_BAY_OCCUPIED - Bay is occupied by a drive that does not
respond to the corresponding SCSI ID.
●
FAULTY_ID_INVALID_BAY - Drive responds to an ID that doesn't have a
valid corresponding bay.
●
WRITE_RETRIES_FAILED - Unable to complete a write operation after
several retries.
●
QUEUE_FULL_ON_ZERO - Drive indicates that its queue is full when we
have no requests outstanding to the drive.
●
SMART_ERROR_REPORTED - Drive has reported a predictive-failure error
when controller is configured to automatically fail [instead of
reporting imminent failure of] drives that report this error.
●
PHY_RESET_FAILED - Phy reset request failed.
●
FR_CHKBLK_FAILED_WRITE - Drive failed write command while checking for
media errors.
●
FR_ATI_TEST_FAILED_WRITE - Drive failed write command while checking
for errors.
●
OFFLINE_ERASE - Drive is offline due to a Secure Erase operation.
●
OFFLINE_TOO_SMALL - Drive is offline because it's a replacement drive
that is too small.
DEWW Smart Array-Meldungen im Windows-Ereignisprotokoll 153