HP ProLiant Gen8 Handbuch Seite 206

Enclosure-Link: Failed to read topology
Enclosure-Link: Got unexpected error from socket: [value]
Enclosure-Link: RUID recovered: [value]
Protokolltyp: LOG_ERR, Fehlertyp: SW
Enclosure-Link: [value] enclosure(s) seen on Enclosure Link. Only
[value:Max_Enclosures] enclosure(s) supported. Please remove [value]
enclosure(s)
Enclosure-Link: Corrupted topology on eth2
Enclosure-Link: Corrupted topology on eth3
Enclosure-Link: Failed to create socket
Enclosure-Link: Failed to detect Enclosure topology
Enclosure-Link: Failed to disable lower chain
Enclosure-Link: Failed to disable upper chain
Enclosure-Link: Failed to enable lower chain
Enclosure-Link: Failed to enable upper chain
Enclosure-Link: Failed to generate EVENT for initial topology detection
Enclosure-Link: Failed to generate EVENT for topology change
Enclosure-Link: Failed to get local address. Will keep retrying
Enclosure-Link: Failed to log into enclosure [value:IpAddress]
Enclosure-Link: Failed to probe newly attached/detached device
Enclosure-Link: Failed to read events from chain
Enclosure-Link: Failed to register with enclosure [value:IpAddress]
Enclosure-Link: Failed to retrieve enclosure addresses from lower elink
chain
Enclosure-Link: Failed to retrieve enclosure addresses from upper elink
chain
Enclosure-Link: Failed to send ICMP packet to host
Enclosure-Link: Failed to update hosts file
Enclosure-Link: Failed to write updated topology map
Enclosure-Link: Found 2 GuestPCs on Enclosure Link. This setup is not
supported.
Enclosure-Link: Ignoring invalid Enclosure Link address
Enclosure-Link: Seeing heavy traffic on Enclosure Link chain. This may
affect topology.
Enclosure-Link: This can also occur if the enclosures have been connected
in a loop which is an unsupported configuration. Please make sure the top
and bottom enclosures are not connected to each other.
Protokolltyp: LOG_INFO, Fehlertyp: Info
182 Kapitel 4 HP Onboard Administrator-Fehler DEWW