HP ProLiant Gen8 Handbuch Seite 455

PuTTY-Utility, PuTTY-Client
reagiert nicht bei Verwendung
von freigegebenem
Netzwerkport 264
R
RBSU nach iLO und Server-
Zurücksetzung nicht verfügbar
254
Redundanter Controller-Betrieb
13
Redundantes ROM
Redundant ROM Detected -
This system contains a valid
backup system ROM. 39
Redundante
Verkabelungskonfiguration
1735-Slot X Drive Array -
Unsupported Redundant
Cabling Configuration
Detected... 69
1737-Slot X Drive Array -
Redundant Cabling
Configuration has excess
Device Paths... 69
Remote Console, Probleme mit
dem Cursor 259
Remote Console, Textfenster wird
nicht aktualisiert 259
Remote Console-Applet besitzt
rotes x 259
RIBCL, Aktualisieren der iLO
Firmware nicht möglich 267
RIBCL-Fehlermeldungen 242
RIS (Remote Installation Services)
Error Occurred Reading RIS
Copy from SCSI Port X Drive
ID 10
RIS Copies Between Drives Do
Not Match 14
SCSI Port X, Drive ID Y RIS
Copies Within This Drive Do
Not Match 15
ROM-Fehler
101-I/O ROM Error 43
101-Option ROM Checksum
Error... 44
101-ROM Error 44
Rückgabecodes, CONREP 234
DEWW
Rückkehr zur Anmeldeseite nicht
möglich 255
S
Schlüsseltabelle, Probleme beim
Erstellen mit ktpass.exe 270
Server-Agent-Fehler 355
Server-Ereignisse, Virtual
Connect 228
Server-Setup 5
Signaltöne 33
SNMP, Ereignisprotokolleinträge
238
SNMP (Simple Network
Management Protocol) 213
SNMP-Informationen, Anfordern
von HP SIM nicht möglich 267
SNMP-Traps
Onboard Administrator-SNMP-
Traps 208
SNMP-Traps 214
Trap-Schweregrade 219
Speicher
172-1-Configuration Non-
volatile Memory Invalid 45
203-Memory Address Error
46
207-Invalid Memory
Configuration - Incomplete
Bank Detected in Bank X 47
207-Invalid Memory
Configuration - Insufficient
Timings on DIMM 47
207-Invalid Memory
Configuration - Single channel
memory... 47
209-Hot-add Memory
Configuration - Boards must
be installed sequentially. 48
Corrected Memory Error
Threshold Passed (Slot X,
Memory Module Y)... 93
Invalid memory types were
found on the same node.
Please check DIMM
compatibility. - Some DIMMs
may not be used 37
Speicher, gespiegelt 49
Speicher, Interleaving 38
Speicher, konfigurieren
207-Invalid Memory
Configuration - DIMM Size
Parameters Not Supported.
46
207-Invalid Memory
Configuration - DIMMs must
be installed in pairs or
sequentially 46
207-Invalid Memory
Configuration - DIMMs Must
be Installed Sequentially 46
207-Invalid Memory
Configuration - Incomplete
Bank Detected in Bank X 47
207-Invalid Memory
Configuration - Insufficient
Timings on DIMM 47
207-Invalid Memory
Configuration - Mismatched
DIMMs within DIMM Bank
47
207-Invalid Memory
Configuration - Mismatched
DIMMs within DIMM Bank...
47
207-Invalid Memory
Configuration - Single channel
memory... 47
207-Invalid Memory
Configuration - Unsupported
DIMM in Bank X 47
207-Invalid Memory
Configuration - Unsupported
DIMM in Socket X 48
207-Memory Configuration
Warning - DIMM In Socket X
does not have Primary Width
of 4 and only supports
standard ECC. 48
Speicher, RAID 34, 49
Speicher-Agents-Fehler 294
Speichereinheit
Storage Enclosure on SCSI
Bus X has a Cabling Error
(Bus Disabled)... 16
Storage Enclosure on SCSI
Bus X Indicated a Door
Alert... 16
Index 431