HP ProLiant Gen8 Handbuch Seite 214

OA: Enclosure Dynamic Power Cap bay opt out list set to [value] by
[value:username].
OA: Enclosure Dynamic Power Cap set to: [value], derated circuit [value],
rated circuit [value] by [value:username].
OA: Enclosure Dynamic Power Cap set to: OFF by [value:username].
OA: Enclosure part number changed from '[value]' to '[value]' by
[value:username].
OA: Enclosure PDU type changed from '[value]' to '[value]' by
[value:username].
OA: Forced takeover requested by user [value:username].
OA: HP SIM certificate [value:subject-CN] added by user [value:username].
OA: HP SIM certificate [value] removed by user [value:username].
OA: LDAP Directory Server certificate(MD5=[value]) installed by user
[value:username].
OA: LDAP Directory Server certificate(MD5=[value]) removed by user
[value:username].
OA: Onboard Administrator [value:bayNumber] name change failed.
OA: Resetting the Onboard Administrator because two-factor authentication
configuration has changed.
OA: Self signed certificate generated and installed by user
[value:username].
OA: Time changed by [value:username].
OA: Time zone changed by [value:username].
OA: Time zone changed from [value] to [value]
OA: Time zone changed to [value]
OA: Two Factor Authentication [enabled/disabled] on Onboard Administrator
by user [value:username].
Protokolltyp: LOG_NOTICE, Fehlertyp: SW
FWSync: Sync failed because the Active and Standby OAs do not have the
same hardware version.
OA: unable to run [value:mount]
OA: Warning: Unable to ping the remote oa_syslog server [value:Address]
Protokolltyp: LOG_NOTICE, Fehlertyp: Info
FWSync: OA firmware sync to [value:versionNumber] complete
OA: [value:protocol] was [enabled/disabled] by user [value:username]
OA: Alertmail domain changed to [value:mailDomain] by user
[value:username]
OA: Alertmail recipient changed to [value] by user [value:username]
190 Kapitel 4 HP Onboard Administrator-Fehler DEWW