HP ProLiant Gen8 Handbuch Seite 135

●
SPIN_UP_FAILURE_IN_RECOVER - "Start Unit" command failed during error
recovery
●
REBUILD_WRITE_ERROR - Drive failed write command after multiple
retries during rebuild.
●
TOO_SMALL_IN_HOT_PLUG - Replacement drive is too small for configured
volume(s).
●
BUS_RESET_RECOVERY_ABORTED - Unable to communicate with drive after
multiple bus resets and retries; may be due to this drive or another
drive that is corrupting the parallel SCSI bus.
●
REMOVED_IN_HOT_PLUG - Drive has been hot-removed.
●
INIT_REQUEST_SENSE_FAILED - "Request Sense" command failed during
device discovery/initialization.
●
INIT_START_UNIT_FAILED - "Start Unit" command failed during device
discovery/initialization.
●
INQUIRY_FAILED - "Inquiry" command failed after multiple retries.
●
NON_DISK_DEVICE - Attached device is not a hard disk per its inquiry
data.
●
READ_CAPACITY_FAILED - "Read Capacity" command failed after multiple
retries.
●
INVALID_BLOCK_SIZE - Drive indicates it is not formatted for 512 bytes
per sector.
●
HOT_PLUG_REQUEST_SENSE_FAILED - "Request Sense" command failed after
drive hot-added.
●
HOT_PLUG_START_UNIT_FAILED - "Start Unit" command failed after drive
hot-added)
●
WRITE_ERROR_AFTER_REMAP - After reassigning a media error reported
during a write command, the write command failed with another media
error.
●
INIT_RESET_RECOVERY_ABORTED - Unable to communicate with drive during
initialization after multiple bus resets and retries; may be due to
this drive or another drive that is corrupting the parallel SCSI bus.
●
DEFERRED_WRITE_ERROR - Drive with write cache enabled reported that it
could not complete a write command that it previously indicated was
successful [lost data].
●
MISSING_IN_SAVE_RIS - Could not write to reserved configuration
sectors after multiple retries.
●
WRONG_REPLACE - A hot-plug tape drive was plugged in as a replacement
into a drive bay that a hard disk was removed from.
●
GDP_VPD_INQUIRY_FAILED - Could not read drive serial number after
multiple retries.
●
GDP_MODE_SENSE_FAILED - Could not read certain mode pages after
multiple retries.
DEWW Smart Array-Meldungen im Windows-Ereignisprotokoll 111