HP ProLiant Gen8 Handbuch Seite 224

OA: Internal health status of interconnect in bay [value:slotNumber]
changed to Failed
OA: Internal health status of interconnect in bay [value:slotNumber]
changed to Unknown
OA: Management Processor on Blade [value:bladeNumber] appears
unresponsive.
OA: Mixing different fan models is not supported. The fan in bay
#[value:fanNumber] must be replaced with the proper part number.
OA: Mixing different power supply models is not supported. The power
supply in bay #[value] must be replaced with the proper part number.
OA: Power Supplies Connected To Both AC and DC Input Lines: Unsupported
Configuration.
OA: Power Supplies Not Connected To Identical Capacity Input Lines.
OA: PS Removed: Bay #[value]
OA: PS Status Changed: Bay #[value] From: [unknown/ok/degraded/failed]
To: [unknown/ok/degraded/failed]
OA: PS Status Changed: Bay #[value] From: [unknown/ok/degraded/failed]
To: [unknown/ok/degraded/failed] - due to communication issues.
Reinserting Power Supplies may correct the issue.
OA: PS Subsystem N + 1 Redundancy - FAILED. Allocated Power: [value]W DC,
Present Power: [value]W AC.
OA: PS Subsystem N + 1 Redundancy Power Limit - FAILED. Allocated Power:
[value]W DC, Power Limit: [value]W DC.
OA: PS Subsystem N + N Redundancy - FAILED. Allocated Power: [value]W DC,
Present Power: [value]W AC.
OA: PS Subsystem N + N Redundancy Power Limit - FAILED. Allocated Power:
[value]W DC, Power Limit: [value]W DC.
OA: PS Subsystem Overload - FAILED. Allocated Power: [value]W DC, Present
Power: [value]W AC.
OA: PS Subsystem Power Limit - FAILED. Allocated Power: [value]W DC,
Power Limit: [value]W DC.
OA: Redundant Onboard Administrator was removed
OA: Required fan is missing from fan bay [value]
OA: The fan in bay #[value:fanNumber] is not supported in this enclosure.
Please replace this fan with the proper part number.
OA: The power management controller firmware on blade [value:bladeNumber]
must be upgraded. Please see customer advisory c01668472.
OA: TRAY microcode update failed
Protokolltyp: LOG_NOTICE, Fehlertyp: SW
OA: Blade [value:bladeNumber] and its partner device need be powered up
in a different order.
200 Kapitel 4 HP Onboard Administrator-Fehler DEWW