HP ProLiant Gen8 Handbuch Seite 176

●
MEDIUM_ERROR_1 - Caused by a particular set of SCSI sense codes that
indicate the drive is in bad shape and its data may be corrupt.
●
MEDIUM_ERROR_2 - Caused by a particular set of SCSI sense codes that
indicate the drive is in bad shape; retries did not help.
●
NOT_READY_BAD_SENSE - Drive is returning unrecognized Not Ready sense
codes.
●
NOT_READY - Drive is not ready and will not spin up.
●
HARDWARE_ERROR - Drive is returning a Hardware Error sense key;
controller unable to get drive back online.
●
ABORTED_COMMAND - Drive is returning an Aborted Command sense key;
controller unable to get drive back online.
●
WRITE_PROTECTED - Drive is returning a sense key indicating it is
write protected.
●
SPIN_UP_FAILURE_IN_RECOVER - "Start Unit" command failed during error
recovery
●
REBUILD_WRITE_ERROR - Drive failed write command after multiple
retries during rebuild.
●
TOO_SMALL_IN_HOT_PLUG - Replacement drive is too small for configured
volume(s).
●
BUS_RESET_RECOVERY_ABORTED - Unable to communicate with drive after
multiple bus resets and retries; may be due to this drive or another
drive that is corrupting the parallel SCSI bus.
●
REMOVED_IN_HOT_PLUG - Drive has been hot-removed.
●
INIT_REQUEST_SENSE_FAILED - "Request Sense" command failed during
device discovery/initialization.
●
INIT_START_UNIT_FAILED - "Start Unit" command failed during device
discovery/initialization.
●
INQUIRY_FAILED - "Inquiry" command failed after multiple retries.
●
NON_DISK_DEVICE - Attached device is not a hard disk per its inquiry
data.
●
READ_CAPACITY_FAILED - "Read Capacity" command failed after multiple
retries.
●
INVALID_BLOCK_SIZE - Drive indicates it is not formatted for 512 bytes
per sector.
●
HOT_PLUG_REQUEST_SENSE_FAILED - "Request Sense" command failed after
drive hot-added.
●
HOT_PLUG_START_UNIT_FAILED - "Start Unit" command failed after drive
hot-added)
●
WRITE_ERROR_AFTER_REMAP - After reassigning a media error reported
during a write command, the write command failed with another media
error.
152 Kapitel 3 HP Smart Array-Fehler DEWW