HP ProLiant Gen8 Handbuch Seite 12

203-Memory Address Error ............................................................................... 46
207-Invalid Memory Configuration Detected. DIMMs installed when no
corresponding processor is detected. ............................................................... 46
207-Invalid Memory Configuration - DIMMs must be installed in pairs or
sequentially ....................................................................................................... 46
207-Invalid Memory Configuration - DIMMs Must be Installed Sequentially ..... 46
207-Invalid Memory Configuration - DIMM Size Parameters Not Supported. ... 46
207-Invalid Memory Configuration - Incomplete Bank Detected in Bank X ...... 47
207-Invalid Memory Configuration - Insufficient Timings on DIMM ................... 47
207-Invalid Memory Configuration - Mismatched DIMMs within DIMM Bank . .. 47
207-Invalid Memory Configuration - Mismatched DIMMs within DIMM
Bank... ............................................................................................................... 47
207-Invalid Memory Configuration - Mismatched DIMMs within DIMM
Bank... ............................................................................................................... 47
207-Invalid Memory Configuration - Unsupported DIMM in Bank X ................. 47
207-Invalid Memory Configuration - Single channel memory... ........................ 47
207-Invalid Memory Configuration - Unsupported DIMM in Socket X ............... 48
207-Memory Configuration Warning - DIMM In Socket X does not have
Primary Width of 4 and only supports standard ECC. ....................................... 48
208-Memory Board Error - This error could be the result of a bad or
improperly installed memory board or a system board issue ............................ 48
209-Online Spare Memory Configuration - No Valid Banks for Online Spare ... 48
209-Online Spare Memory Configuration - Spare Bank is Invalid ..................... 48
209-Hot-add Memory Configuration - Boards must be installed sequentially. . . 48
209-Invalid Lockstep memory configuration ...................................................... 49
209-Mirror Memory Configuration - Memory Sizes on boards X and Y do
not match .......................................................................................................... 49
209-RAID Memory Configuration - Memory Sizes on boards X and Y do not
match ................................................................................................................ 49
210-Memory Board Power Fault on board X ..................................................... 49
210-Memory Board Failure on board X ............................................................. 49
212-Processor Cache Size Mismatch Detected - System Performance may
be Erratic! .......................................................................................................... 49
212-Processor Failed, Processor X .................................................................. 50
228 - DIMM Configuration Error - Processor X, Channel Y .............................. 50
229 - DIMM Configuration Error - Processor X, DIMM Y .................................. 50
230 - DIMM Configuration Error - Processor X, Channel Y .............................. 50
231 - DIMM Configuration Error ........................................................................ 50
232 - Memory initialization error - Processor X, DIMM Y failed. ....................... 51
233 - DIMM initialization Error - Memory access locked by LT. ........................ 51
234 - DIMM Initialization Error - Receive Enable error. Cannot train
memory. ............................................................................................................ 51
xii DEWW