HP ProLiant Gen8 Handbuch Seite 182

temperature is nearing the preset temperature limit of <temperature limit>
°C. The current temperature is <current temperature>°C as reported by
sensor number <sensor number>. The external Smart Array controller may
enact precautionary measures to prevent data loss should the temperature
reach the operating limit.
The external Smart Array controller is attached to the host side Smart
Array controller <controller name / slot information>.
Meldungs-ID: 24796
Schweregrad: Informativ
Protokollmeldung: The external Smart Array controller located in the MSA
chassis labeled as <chassis label> is indicating that a previously
existing temperature condition on the controller from sensor <sensor
number> has been corrected. All of the temperature sensors are now
reporting acceptable temperature levels.
The external Smart Array controller is attached to the host side Smart
Array controller <controller name / slot information>.
Meldungs-ID: 24797
Schweregrad: Informativ
Protokollmeldung: The <drive type> physical drive located in bay <bay number>
has passed a pre-defined usage threshold. It currently has <days or
percent> <days of / percentage> usage remaining. Indicates that the drive
is approaching the maximum usage limit for writes (wear out). This drive
can be found in box <box number> which is connected to port <port number>
of the array controller <controller name / slot information>.
Meldungs-ID: 24798
Schweregrad: Informativ
Protokollmeldung: The external Smart Array controller located in the MSA
chassis labeled as <chassis label> is reporting that the <drive type>
physical drive located in bay <bay number> has passed a pre-defined usage
threshold.
It currently has <days or percent> <days of / percentage> usage
remaining. Indicates that the drive is approaching the maximum usage
limit for writes (wear out).
The external Smart Array controller is attached to the host side Smart
Array controller <controller name / slot information>.
Meldungs-ID: 24799
Schweregrad: Warnung
Protokollmeldung: The <drive type> physical drive located in bay <bay number>
could not be authenticated as a genuine HP hard drive. This drive's
status LEDs will not be controlled. This drive can be found in box
<box number> which is connected to port <port number> of the array
controller <controller name / slot information>.
158 Kapitel 3 HP Smart Array-Fehler DEWW