HP ProLiant Gen8 Handbuch Seite 454

WARNING - Mixed Feature
Processors Were Detected
22
WARNING - Resetting
Corrupted CMOS 22
WARNING - Resetting
Corrupted NVRAM 22
WARNING - Resetting
Corrupted System
Environment 22
WARNING - Restoring Default
Configurations as
Requested 22
Post-Fehlermeldungen, nicht
numerisch 33
POST-Fehlermeldungen, Serie
100 43
POST-Fehlermeldungen, Serie
1100 57
POST-Fehlermeldungen, Serie
1500 57
POST-Fehlermeldungen, Serie
1600 58
POST-Fehlermeldungen, Serie
1700 62
POST-Fehlermeldungen, Serie
200 46
POST-Fehlermeldungen, Serie
300 54
POST-Fehlermeldungen, Serie
400 55
POST-Fehlermeldungen, Serie
600 56
POST-Fehlermeldungen und
Signaltöne 33
POST-LED-Anzeigen 237
Power-Modul 92
Power Regulator
(Leistungsregler) 43
Power Regulator (Leistungsregler),
Fehlerbehebung 43
PPM (Prozessor-Power-Modul)
36
Probleme mit dem Betriebssystem
Automatic operating system
shutdown initiated due to fan
failure 92
Automatic Operating System
Shutdown Initiated Due to
Overheat Condition... 92
430 Index
Probleme mit dem
Diskettenlaufwerk
601-Diskette Controller Error
56
602-Diskette Boot Record
Error 56
605-Diskette Drive Type
Error. 56
Probleme mit der Tastatur
301-Keyboard Error 54
301-Keyboard Error or Test
Fixture Installed 54
303-Keyboard Controller
Error 55
304-Keyboard or System Unit
Error 55
Network Server Mode Active
and No Keyboard Attached
38
No Keyboard Present 38
Probleme mit Festplatten
SCSI Port X, Drive ID
Y...S.M.A.R.T. Predictive
Failure Errors Have Been
Detected in the Factory
Monitor and Performance
Data... 15
SCSI Port X, Drive ID
Y...S.M.A.R.T. Predictive
Failure Errors Have Been
Detected in the Power Monitor
and Performance Data... 16
SCSI Port X, Drive ID Y
Firmware Needs Upgrading
14
SCSI Port X, Drive ID Y Has
Exceeded the Following
Threshold(s) 15
SCSI Port X, Drive ID Y is not
Stamped for Monitoring 15
SCSI Port X, Drive ID Y May
Have a Loose Conncetion...
15
SCSI Port X, Drive ID Y RIS
Copies Within This Drive Do
Not Match 15
SCSI Port X Drive ID Y Failed -
REPLACE (failure
message) 14
Probleme mit Lüftern
Fan Solution Not Fully
Redundant 34
Fan Solution Not Sufficient 34
Profilereignisse, Virtual Connect
229
Prozessoren
Internal CPU Check -
Processor 36
Memory found on unpopulated
Node. Ein Prozessor muss
installiert werden, damit der
Speicher verwendet werden
kann. 37
Mixed processor speeds
detected. Please make sure
that all processors are the
same speed. System
Halted! 37
Processor X Unsupported
Wattage. 39
This system only supports 667
MHz Front Side Bus Speed
Processors. One or more 800
MHz Front Side Bus Speed
Processors have been
initialized at 667 MHz. System
Halted! 41
Unsupported Processor
Detected System will ONLY
boot ROMPAQ Utility. System
Halted. 42
Prozessor-Fehlercode 96
Prozessor-Fehlercodes aus
Windows Ereignisprotokoll 96
Prozessorprobleme
212-Processor Failed,
Processor X 50
Internal CPU Check -
Processor 36
Mixed processor speeds
detected. Please make sure
that all processors are the
same speed. System
Halted! 37
Prozessor-Stepping 43
Prüfsummenfehler 64
PuTTY Utility, anfängliche PuTTY-
Eingabe langsam 264
DEWW