Linux-Protokollmeldungen; Verwaltungs-Protokollmeldungen - HP ProLiant Gen8 Handbuch

OA: Momentary Press virtual command enacted on blade [value:bladeNumber]
by user [value:username].
OA: Onboard Administrator in bay [value:bayNumber] was restarted by user
[value:username].
OA: Power limit was set to [value] by user [value:username].
OA: Power savings mode was set to [ON/OFF] by user [value:username].
OA: Power subsystem redundancy mode was set to [value] by user
[value:username].
OA: Press and Hold virtual command enacted on blade [value:bladeNumber]
by user [value:username].
OA: Reboot virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Session on interconnect [value:bayNumber] cleared by [value].
OA: Standby Onboard Administrator flashed successfully.
OA: Virtual power command enacted on interconnect [value:number] by user
[value:username].
OA: Warning: Not all VC-Enet modules are on the same VLAN ID.

Linux-Protokollmeldungen

Protokolltyp: LOG_NOTICE, Fehlertyp: Info
OA: Authentication failure for user [username] from [remote host]
requesting [value].
OA: Authentication failure for user [username] from Enclosure Link
requesting [value].
OA: Authentication failure for user [username] on [value].
OA: Authentication failure for user [username] on the OA KVM.
OA: Authentication failure for user [username] on the OA serial console.
OA: Authentication failure for user [username] requesting [value]

Verwaltungs-Protokollmeldungen

Protokolltyp: LOG_EMERG, Fehlertyp: SW
OA: Internal System Firmware Error, Rebooting.
Protokolltyp: LOG_WARNING, Fehlertyp: HW
OA: A port mismatch was found with server blade bay [value:bladeNumber]
and interconnect bay [value:slotNumber]
OA: Temperature of I/O module in slot [value:slotNumber] is at alert level
Protokolltyp: LOG_WARNING, Fehlertyp: SW
OA: iLO in bay [value] has not responded to the previous [value:count]
capping requests from the Enclosure Dynamic Power Cap.
196 Kapitel 4 HP Onboard Administrator-Fehler DEWW