HP ProLiant Gen8 Handbuch Seite 213

OA: Failed to copy firmware image to the Standby Onboard Administrator
OA: Failed to register for events on the Standby Onboard
Administrator(error=0x[value])
OA: Failed to send URB message to configured endpoint. Check URB settings.
OA: Firmware image corrupt. Please verify the image and retry
OA: Please inspect the system log on the Standby Onboard Administrator
for further details
OA: The Active and Standby Onboard Administrators may not be
communicating reliably
Protokolltyp: LOG_WARNING, Fehlertyp: Info
FWSync: OA firmware sync initiated by user [value:username]
FWSync: Other (STANDBY) OA will be upgraded to firmware
[value:versionNumber]
FWSync: This (ACTIVE) OA will be upgraded to firmware
[value:versionNumber]
OA: Flashing Active Onboard Administrator. Initiated by user
[value:username]
OA: Flashing Standby Onboard Administrator. Initiated by user
[value:username]
Protokolltyp: LOG_CRIT, Fehlertyp: SW
OA: Enclosure Name change failed.
OA: Failed NVRAM commit of Enclosure Dynamic Power Cap bay opt out list
by [value:username].
OA: Failed to reset the Onboard Administrator.
OA: Rack Name change failed
Protokolltyp: LOG_CRIT, Fehlertyp: Info
Log cleared by [value:username].
OA: CA certificate (issuer = [value:issuer-CN]) installed by user
[value:username].
OA: CA certificate (issuer = [value:issuer-CN]) removed by user
[value:username].
OA: Certificate for user [value:username] installed by user
[value:username].
OA: Certificate for user [value:username] removed by user
[value:username]. All web sessions (if any) were ended.
OA: Certificate owner field set to ([SAN/SUBJECT]) on Onboard
Administrator by user [value:username].
OA: Certificate Revocation check [enabled/disabled] on Onboard
Administrator by user [value:username].
OA: Downloaded HPSIM certificate by user [value:username]
DEWW SysLog-Meldungen 189