3
INSTALLATION OF INDOOR UNIT
How to remove the panel before piping and electric wiring
1. Remove the air inlet grille (4 hooks at top and bottom each) and then remove the fan guard (6 screws) for piping
work.
2. Remove the front panel (2 screws) for wiring work
In case of fixing the indoor unit to wall
Fix the indoor unit to the wall as described below.
1. Referring to the following figure, fix four M8 anchor
bolts to the wall.
2. As shown in the figure, attach the bolts preciously
to the upper two anchor bolts.
3. Using a screwdriver, etc, open knockout hole at
rear side of the indoor unit.
4. Hang the indoor unit to the anchor bolts.
5. Tighten the nuts to the two lower anchor bolts.
700mm
520mm
Mount the upper two
Tighten the lower two
nuts as shown in the
nuts after the unit has
figure below.
been mounted.
1 to 2mm
15mm MAX
Fan guard
125mm
215mm
Screwdriver
Knockout hole
Hock
Hock
In case of fixing the indoor unit to floor
To fix the indoor unit to the floor, pass two anchor bolts
attached on the floor through a hole of the bottom
plate of the indoor unit, and then tighten and fix it with
the nuts.
Anchor bolts (two at left and right)
Installation of remote controller
(Sold separately)
For installation of the wired remote controller, follow
the Installation Manual attached with the remote
controller.
For installation of the wireless remote controller, follow
to the Installation Manual attached to the remote
controller.
• Do not put the remote controller on the place where
is exposed to direct sunlight or near a stove, etc.
• Operate the remote controller, check the indoor unit
surely receives the signal, and then install the
remote controller. (Wireless type)
• Install the remote controller 1m apart from the
devices such as TV or stereo. (Image may be
disturbed or noise may be output.) (Wireless type)
5
Front panel
Air inlet grile
Hock
Hock
Rear
Front
400mm
275mm