VHF R5 Originalbetriebsanleitung Seite 59

R5 – Maintenance and do-it-yourself
F . 83 C
IG LEANING THE INNER CONE OF THE SPINDLE
11. Clean the collet chuck with the brush of the service
set.
a. Insert the brush into the collet chuck until the
end of the brush aligns with the end of the
collet chuck.
Do not push any further because
otherwise dirt my get into the thread
of the collet chuck.
F . 84 T
IG HE END OF THE BRUSH MARKED WITH A VERTICAL
ORANGE LINE
b. Rapidly pull the brush out of the collet chuck
and twist it at the same time.
F . 85 C
IG LEANING THE COLLET CHUCK
c. Repeat the last 2 steps multiple times.
12. Thoroughly clean the complete outer surface of the
13. Put a small amount of the collet grease on the index
14. Apply the smeared collet grease to the flanks of the
F
IG
TO BE APPLIED IS MARKED IN BLUE
MARKED IN RED
15. Insert the collet chuck into the spindle. Screw the
Original Operating Instructions: R5
Version: 12/16/2021
Damaging of the spindle
NOTICE
when using the wrong
grease or applying the grease incorrectly
If you use unsuitable grease or if grease gets into
the longitudinal slots of the collet chuck, the
machine may get damaged.
Before applying the grease, ensure that the col-
let chuck is perfectly clean.
Ensure that no grease gets into the longitudinal
slots of the collet chuck.
Only use a very small, less than pinhead-size
amount of the grease.
Only use the provided grease of the service set.
collet chuck with a clean and dry cloth.
F . 86 C
IG LEANING THE COMPLETE OUTER SURFACE OF THE COLLET
CHUCK WITH A CLOTH
finger and smear it with the thumb.
collet chuck.
. 87 G ;
REASING THE COLLET CHUCK
;
SLOT THAT MAY NOT BE GREASED IS
collet chuck in by twisting it counter-clockwise with
your hand.
EN 59
SURFACE IN WHICH GREASE IS