Directclean Technology - VHF R5 Originalbetriebsanleitung

R5 – Operation: Executing jobs
F . 60 R
IG EMOVING THE TOOL FROM THE COLLET CHUCK
9. Close the working chamber door.
10. Confirm the current message.
The following happens:
a. The collet chuck closes.
b. If your machine is equipped with an automatic
working chamber door, the door automatically
closes.
c. The spindle moves to its default position.

7.3 DirectClean Technology

The DirectClean Technology of the R5 improves the
cleanliness of the machine, especially when alternating
between wet and dry jobs. It consists of the following
processes:
The blowing and drying process is triggered by the
sequence and type of jobs. You can find the corres-
ponding details in the table below.
Can be deactivated in the DENTALCNC settings
1
Can be reduced to 2 minutes in the DENTALCNC settings
*
D
Manually starting the drying program
You can also start the drying program manually.
1. Open the DENTALCNC Application settings with the
2. Open the Machine maintenance view with the
3. Select the following icon:
Original Operating Instructions: R5
Version: 12/16/2021
Blowing off the blank with compressed air
n
Drying the working chamber with heated
n
compressed air
Discharging machining debris during machining
n
with the ionizer for suitable blank types
Job followed by
Dry job no job Blowing off the
blank
Wet no job Drying
job
Dry job any job Blowing off the
blank
Wet no job Drying
job
Wet dry job Drying
job
Wet wet job Drying
job
Duration in minutes
Blank inserted into the working chamber
Blank(s) loaded from the blank magazine
To minimize the cleaning time, we recommend
executing all dry jobs before all wet jobs.
following icon in the main icon bar:
following icon in the local icon bar:
EN 47
Program D
2
1
15
*
2
15
*
15
15
*