VHF R5 Originalbetriebsanleitung Seite 38

EN 38
F . 45 P (
IG OSITIONING PINS LEFT MARKINGS
(
GROOVE IN THE SHAFT RIGHT MARKING
4. Insert the shaft of the block into the desired pos-
ition in the block holder until it is firmly seated.
F . 46 I
IG NSERTING A BLOCK INTO THE BLOCK HOLDER
;
FROM BELOW GROOVE AND POSITIONING PIN MARKED GREEN
5. Use the provided torque wrench to fixate the block
with the corresponding fixing screw. Tighten the
screw firmly.
F . 47 S
IG CREWING DOWN THE SCREW TO IMMOBILIZE THE BLOCK
)
MUST LIE IN THE
)
(
HERE SHOWN
)
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Operation: Preparing jobs
You can now mount the block holder.