Exchanging The Gasket And Valves Of The Blank Holder - Vhf R5 Originalbetriebsanleitung

EN 62
5. Screw the carbon filter cap off the filter.
F . 96 O
IG PENING THE CARBON FILTER
6. Empty the filter and dispose of the activated carbon
pellets.
7. If the mesh filter is soiled, clean it under running
water.
8. Clean the carbon filter and dry it with a cloth.
9. Fill new activated carbon pellets into the carbon fil-
ter.
F . 97 R
IG EPLACING THE ACTIVATED CARBON PELLETS
10. Firmly close the carbon filter with the cap.
11. If the filter mesh is soiled, pull it off the cooling
liquid filter and rinse it under running water.
12. Clean the coupling of the cooling liquid tank.
Cleaning the coupling of the cooling liquid tank – on

page 64
13. Reassemble the cooling liquid filter. Make sure that
the fine filter covers the complete filter. If the fine fil-
ter is too long, cut it to the length of your cooling
liquid filter.
14. Screw down the filter in the cooling liquid tank
with your hand.
15. Fill new cooling liquid into the tank.
16. Reinsert the cooling liquid tank until the tank is
properly attached to the machine.
8.12 Exchanging the gasket and
valves of the blank holder
If the blank holder no longer properly fixates blanks,

exchanging the gasket and valves of the blank holder

may solve the issue.
1. Have ready:
2. Open the working chamber door.
3. Move and tilt the blank holder manually towards
4. Unscrew the 4 screws (marked orange) that fixate
5. Lift off the workholding strap.
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Maintenance and do-it-yourself
A damp cloth
n
Maintenance set for the blank holder
n
the front of the machine until you can reach the
screws of the workholding strap.
F . 98 M
IG OVING THE BLANK HOLDER
the workholding strap of the blank holder.
F . 99 S
IG CREWS OF THE WORKHOLDING STRAP