How To Proceed In Case Of A Power Failure - VHF R5 Originalbetriebsanleitung

R5 – Operation: Executing jobs
6. Close the working chamber door.
7. Resume the job.
DENTALCNC allows you to resume the job from
the last tool change. For more information, see
the corresponding documentation.
If tools break regularly, you can find additional
information in the troubleshooting section:
Troubleshooting – on page 76

7.4.4 How to proceed in case of a pow er fail-
ure
when you open it manually
If compressed air is being conducted through the
machine while you open the multi-purpose compart-
ment flap, the flap mechanics may get damaged.
As long as the machine is not powered, you do not
have access to the working chamber.
F
IG
COMPARTMENT
Original Operating Instructions: R5
Version: 12/16/2021
Damaging of the multi-
NOTICE
purpose compartment flap
Before you manually open the multi-purpose com-
partment flap, close the external compressed air sup-
ply valve.
After a short power failure, restart the machine and
the CAM computer.
If you need to access the working chamber in case of
a longer power failure, perform an emergency open-
ing of the working chamber door.
If you need to access the multi-purpose com-
partment, do the following:
Close the external compressed air supply
valve.
Carefully pull the flap down with your hands.
. 61 M
ANUALLY PULLING DOWN THE FLAP OF THE MULTI
EN 49
-
PURPOSE