Cooling Lubricant; Determining The Ph Value Of The Cooling Liquid With Test Strips; Emptying The Strainer Basket; Exchanging Or Filling In The Cooling Liquid - VHF R5 Originalbetriebsanleitung

EN 34

6.6.1 Cooling lubricant

When processing titanium blanks:
Add the cooling lubricant Tec Liquid Pro to the cool-
ing liquid. The mixing ratio is indicated on the bottle
label. Determine the pH value of the cooling liquid.
Determining the pH value of the cooling liquid with

test strips – see below
Tec Liquid Pro is available from customer
service.
6.6.2 Determining the pH value of the cool-
ing liquid w ith test strips
If you added cooling lubricant to the cooling liquid,
you need to check the pH value of the cooling liquid to
determine whether you need to exchange it.
Determine the pH value of the cooling liquid directly
after adding the cooling lubricant and when you
didn't use the machine for 2 days.
To determine the pH value of the cooling liquid with
test strips, do the following:
Test strips are available from customer service.
a. Hold one test strip into the cooling liquid for a
few seconds.
b. Compare the colors on the test strip with the
indications on the container of the pH test strips.
The colors on the test strip match the pH value 9
on the container.
F . 35 U H (
IG SED P TEST STRIP RIGHT
1. The pH value indicated on the container
2. Colors indicated on the container
3. pH test strip that was used to test the cooling liquid
If the pH value is below 9 or if the change interval in
the maintenance table has been exceeded,
exchange the cooling liquid.
)
AND INDICATIONS ON THE CONTAINER
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Operation: Preparing jobs

6.6.3 Emptying the strainer basket

You can empty the strainer basket into a collecting
container as follows:
1. Lift the cover off the tank.
2. Use the recessed surfaces at the sides of the strainer
basket to pull it upwards.
F . 36 R
IG EMOVING THE STRAINER BASKET
)
COLORED ORANGE
3. Tap out the strainer basket into the collecting con-
tainer. You can use water or compressed air to fur-
ther clean the strainer basket.
The strainer basket is completely void of machining
residues.
6.6.4 Exchanging or filling in the cooling
liquid
You can fill in or exchange the cooling liquid as
follows:
1. To exchange the liquid and clean the cooling liquid
tank, have the following items readily available:
Collecting container that can hold approx.
n
10 l
Cleaning brush
n
Water for cleaning the cooling liquid tank
n
2. Ensure that sufficient cooling liquid is available.
3. Close the working chamber door.
4. Open the multi-purpose compartment.
5. Pull the cooling liquid tank out of the compartment
in the direction indicated by the arrow (
on the facing page ).
When you tilt the cooling liquid tank, the
cover will not prevent the cooling liquid
from leaking.
(
RECESSED SURFACES
Fig. 37
