Cleaning The Collet Chuck - VHF R5 Originalbetriebsanleitung

EN 58

8.9 Cleaning the collet chuck

You need to clean the collet chuck with the spindle
service set which was provided with your machine.
Damaging of the spindle
NOTICE
when cleaning with
compressed air
If you clean the collet chuck with compressed air, the
spindle bearings can be damaged.
Clean the collet chuck only with the appropriate ser-
vice set.
F . 79 S
IG PINDLE SERVICE SET
1. Cleaning brush
2. Knurled nut
3. Tube of collet chuck grease
4. Cleaning cone
To clean the collet chuck do the following:
1. Have the spindle service set ready.
2. Close the working chamber door.
3. Open DENTALCNC's general application
settings with the depicted icon in the
main icon bar.
4. Open the Machine parameters view with
the depicted icon in the local icon bar.
5. Move the axes into the tool
change position by selecting
the depicted icon in the Machin-
ing view in DENTALCNC.
The spindle moves into the position for collet chuck
cleaning.
6. Open the working chamber door.
7. Untighten the collet chuck with the knurled nut:
a. Insert the pin of the knurled nut into the col-
let chuck.
b. Ensure that the collet chuck fully sits in the
recess of the knurled nut.
8. Unscrew and remove the collet chuck with your
9. Put the knurled nut and the collet chuck aside
10. Clean the inner cone of the spindle with the clean-
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Maintenance and do-it-yourself
F . 80 R
IG ECESS IN KNURLED NUT
c. Twist the knurled nut counter-clockwise.
F . 81 U
IG NTIGHTENING THE COLLET CHUCK WITH THE KNURLED NUT
hand.
F . 82 U
IG NSCREWING THE COLLET CHUCK
)
ILLUSTRATION WITH YOUR HAND
within reach.
ing cone of the service set.
( )
MARKED ORANGE
(
MARKED ORANGE IN LEFT