Replacing The Tool Magazine Inserts - VHF R5 Originalbetriebsanleitung

R5 – Maintenance and do-it-yourself
8.20 Replacing the tool magazine
inserts
When tool magazine inserts are worn, they should be
replaced. New inserts are delivered without holes for
the tools. The holes must be drilled into the inserts
with the machine.
Your machine comes with tool magazine inserts as
n
spare parts and with the drill tool.
Additional inserts and drill tools are available via
n
customer service.
The documentation for the manufacturing soft-
ware contains step-by-step instructions for
drilling the holes into the inserts. Below you
find a description of how to replace the tool
magazine insert in the machine.
You can replace tool magazine inserts as follows:
1. Have the spare tool magazine insert readily avail-
able.
2. Open the working chamber door.
3. Pull the tool magazine out of the working chamber.
4. Remove all tools from the tool magazine.
5. Unscrew the 4 screws on the bottom side of the
tool magazine (
Fig. 114 see below

see below , step 1).
F . 114 T 4
IG HE SCREWS ON THE BOTTOM SIDE OF THE TOOL
( )
MAGAZINE MARKED ORANGE
6. Lift the cover off the magazine (
, step 2).
below
7. Remove the existing tool magazine insert (
115 see below , step 3) and replace it with a new
one.
8. Put the cover back onto the tool magazine and
screw it down.
9. Remount the tool magazine in the working cham-
ber.
10. Follow the instructions in the documentation for
,
Fig. 115

Fig. 115 see

Fig.

Original Operating Instructions: R5
Version: 12/16/2021
DENTALCNC and drill the tool positions using the
provided drill bit.
F . 115 D
IG ISASSEMBLING THE TOOL MAGAZINE AND REMOVING THE
INSERT
EN 69