Display Transducer - Endress+Hauser iTEMP TMT 165 FOUNDATION Fieldbus Betriebsanleitung

11 Appendix
Index Parameter
15 PRIMARY_VALUE
_RANGE
13 PRIMARY_VALUE
_TYPE
27 SENSOR_
CONNECTION
39 SENSOR_
TRANSDUCER_
NUMBER
20 SENSOR_TYPE
28 SECONDARY_
VALUE
29 SECONDARY_
UNIT
Index Parameter
14 ALPHA_NUM
7 BLOCK_TAG_
PARAM
12 DECIMAL_POINT
_NUMBER
63 DISPLAY_
REFRESH
11 INC_DEC
8 INDEX_RELATIVE
10 MNEMONIC
120
Transducer Block
Write access with
operating mode
(MODE_BLK)
Static/read only
Static
Static
Static
Static
Read only

11.4 Display Transducer

The following table shows the values in the 'Display Transducer' block that can be
indicated on the display.
Display Transducer
Write access with
operating mode
(MODE_BLK)
Static
Static
Static
Dynamic
Static
Static
FOUNDATION Fieldbus temperature transmitter
Displays the measurement range, the engineering units and decimal point
for the process temperature.
2
Note!
The measurement range set-up and engineering units is done in the
relevant Analogue Input Function Block using the parameter group
XD_SCALE (see page 135).
Displays the measuring method for the first process variable.
Display: Process temperature
Differential temperature backup
Sensor connection mode:
Double two wires
Two wires
Three wires
Four wires
Selection of transducer number
Display sensor type.
Display of actual measurement and reference point.
Unit for SECONDARY_VALUE
• Value
Display of values > 10000 using active numeric or alphanumeric field
• MNEMONIC
Values are only displayed in the numeric field
Block-TAG of the parameter to be displayed
Number of decimal points
Updating the display
Setting the round up system
Index of the parameter to be displayed 0 to 65535
Display text for the alphanumeric field max. 16 characters, up to non-
scrolled 5 characters
Description
Description
Endress+Hauser