Switching Off The Genset; Care And Maintenance; Cleaning And Care - Eisemann BSKA V2 RSS Betriebsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

6.5

A short run-down phase ensures that the genset is cooled sufficiently after use. You should

therefore follow the sequence below when you switch off the genset:

First switch off the electrical consumers or disconnect the supply cables from the genset's

sockets.

Let the engine run without load for approximately 1 more minute in order to guarantee

optimum generator cooling.

Switch off the genset by turning the engine switch to the position 0.

Clean the genset after every use.

To keep the genset ready for operation at all times, you should clean it after every use and

inspect it for damage. Any faults found must be remedied immediately and the care and

maintenance measures described below must be performed regularly. For major transport

or prior to long-term storage of the genset, additional measures are necessary to preserve its

function and operational reliability.

7.1

Carry out the following care measures after every use:

Remove dust and coarse dirt from all components:

– Use the usual tools such as a hand brush or cleaning cloth.

– If necessary, you can use water and a mild detergent suitable for removing oil and

fuel residues. However, make sure that no water enters the switch box.

– In particular, remove dust and stuck-on materials from the housing's ventilation slots.

102

904217 – 2018-11