Spark Arrester - Husqvarna TE 450 2003 Werkstatt-Handbuch

BOZZA
The TE,SMR- USA/CDN muffler is equipped with a "Spark arrester" approved by the U.S. Forest Service. This muffler improves both
the
performance and the efficiency.
" SPARK ARRESTER" MAINTENANCE AND CLEANOUT INSTRUCTIONS
Proceed as follows:
A: Remove the screws (1) and the R.H. side panel (2). Unhook springs (3) fastening the muffler (4) to the exhaust pipes.
B: Remove the two screws fastening the muffler to the rear frame.
Note*: If silencer or exhaust are difficult to remove, help to slide them apart by tapping gently with a rubber or plastic hammer.
C: remove the six rivets (5) and the endcap (6) from silencer's body;
D: examinate SPARK ARRESTER conditions and remove, if necessary, carbon particles from the SPARK ARRESTER screen;
E: if necessary, inflate air on the SPARK ARRESTER screen, in the opposite direction in respect of the exhausted gas flow;
F: assemble the front endcap on the silencer's body, mounting the screws in the correct position, providing a tight connection
between
endcap and silencer's body, using, if necessary, a silicone paste;
G: re-assemble the silencer on motorbike.
Due to the SPARK ARRESTER position on the silencer, if you need only to check the SPARK ARRESTER conditions you can:
A: disassemble the silencer from motorbike;
B: check SPARK ARRESTER conditions simply looking into the silencer from front endcap opening;
C: if the check is positive, you can proceed in re-assembling the silencer on the motorbike;
D: if the check is negative, proceed with the maintenance and cleanout procedure.
Z.4
NOTE PER I MODELLI USA/CDN- AUS
NOTES FOR USA/CDN- AUS MODELS
NOTE POUR LES MODÈLES USA/CDN- AUS
ANMERKUNG FÜR MODELL USA/CDN- AUS
NOTAS POR LOS MODELOS USA/CDN- AUS

SPARK ARRESTER

DRAFT
Part. N. 8000 A2925 (03-2004)