Setup Procedures - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

English
Ensure that all shipping and packaging materials have been removed from the product(s) prior to use.
Unpack the cartons and check all items for proper operation. It is important that the cot is working properly before
it is put into service. Have a qualified service technician use the Product Inspection checklist on
operation instructions to check the cot before it is put into service. See Figure 2 on
components.
The patient compartment of the vehicle in which the cot will be used must have a:
• Smooth rear edge for cot loading.
• Level floor large enough for the folded cot.
• Stryker Model 6370/6377/6378/6379 or 6371 Cot Fastener System (not included).
• In-fastener shut-off module installed and positioned properly (see
• Space to properly install the safety hook.
Note: Loose items or debris on the patient compartment floor can interfere with the operation of the safety hook and
cot fastener. Keep the patient compartment floor clear.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
WARNING
• Improper usage of the cot can cause injury to the patient or operator. Operate the cot only as described in this
manual.
• Do not modify the cot or any components of the cot. Modifying the product can cause unpredictable operation
resulting in injury to the patient or operator. Modifying the product also voids its warranty (see
• Any emergency vehicle to be used with this cot must have the in-fastener shut-off system installed (see
Note:
• This manual should be considered a permanent part of the cot and should remain with the product even if the cot
is subsequently sold.
• Stryker continually seeks advancements in product design and quality. Therefore, while this manual contains the
most current product information available at the time of printing, there may be minor discrepancies between your
cot and this manual. If you have any questions, please contact Stryker Customer Service or Technical Support
at (800) 327-0770 or (269) 324-6500.
Return To Table of Contents
1-18

Setup Procedures

page
6510-009-005 REV A
page 1-20
page 1-11 to identify all of the cot
1-24).
page
www.stryker.com
and the
1-86).
page 1-24).